Joint method of PU conveyor belt of vibrating disk
Release Time:
2021-11-12
First, this method is suitable for the general diameter of more than 10mm precision vibration disc round belt, as well as all kinds of triangle belt, pattern belt and other belts can be applied.
First, this method is suitable for the general diameter of more than 10mm precision vibration disc round belt, as well as all kinds of triangle belt, pattern belt and other belts can be applied.
Two, the connection component: aluminum fixture, constant temperature heater, scissors.
Third, the use of:
1. Fix it. The belt that needs to be connected is fixed in the groove (generally V, O groove) under the aluminum fixture (the splint mainly refers to the gasket and nut).
Specific practices: the two sides of the nut and nut fixed gasket take off (depending on the diameter of the belt operation, if the belt can be directly inserted into the groove, do not have to remove the nut and gasket), the belt into the groove, the gasket and nut re fixed above the groove, both sides of the cleats in a parallel state, spacing about 2cm is appropriate (can be placed in the middle of the thermostat heater);
2. Heat. The thermostatic heater is energized to a constant temperature (the best temperature for belt connection is 160-180 degrees), the fixed belt is heated (the premise is that the heated belt should not appear bubbles, otherwise the connection effect will be affected), and then butt, tighten the manual clamp nut under the fixture until the belt butt is tight;
3. Reprocessing. The belt joint of the vibration disk is completed, and it is taken out after it is completely cooled, and the belt is scraped and smoothed.
Related News
Follow us
Copyright - 2023 All Rights Reserved. Kunshan Yiheda Intelligent Technology Co., Ltd. www.300.cn SEO